This site is intended for healthcare professionals

Go to /sign-in page

You can view 5 more pages before signing in

Protocol for management of haemodynamically unstable ventricular tachycardia

Authoring team

The steps used in the resuscitation procedure are outlined:

  • provide high flow oxygen
  • establish i.v. access
  • consider sedation or ideally, intubation with general anaesthesia
  • perform cardioversion i.e. synchronised DC shocks
    • for a monophasic defibrillator, start at 100 J
    • if VT persists, increase to 200 J
    • if VT persists, increase to 360J
    • (if using a biphasic defibrillator, use the equivalent biphasic energy levels)
  • check serum potassium and correct if less than 4 mmol/l:
    • give up to 60 mmol potassium chloride at maximum rate of 30 mmol per hour
  • if hypokalaemic, assume patient also to be hypomagnesaemic:
    • give 10 mmol magnesium sulphate over 30 minutes (5 mls of 50% solution)
  • if VT persists, obtain expert help; but consider:
    • amiodarone 150 mg in 20 mls 5% dextrose over 10 minutes
    • further cardioversion
    • other anti-arrhythmics
    • overdrive pacing

Create an account to add page annotations

Annotations allow you to add information to this page that would be handy to have on hand during a consultation. E.g. a website or number. This information will always show when you visit this page.

The content herein is provided for informational purposes and does not replace the need to apply professional clinical judgement when diagnosing or treating any medical condition. A licensed medical practitioner should be consulted for diagnosis and treatment of any and all medical conditions.

Connect

Copyright 2024 Oxbridge Solutions Limited, a subsidiary of OmniaMed Communications Limited. All rights reserved. Any distribution or duplication of the information contained herein is strictly prohibited. Oxbridge Solutions receives funding from advertising but maintains editorial independence.